MOVI Processor gets too hot

Hello,
Could somebody help me? :slight_smile:
The processor of my Movi gets too hot.
I want to build a led stripes voicecontrol over infrared.Moreover I want to turn on my speakers only if when I want to. (I use a relay instead of the power button of my speakers).
For this project i use a fake Arduino R3 circuit board (called: smraza uno r3). I use a 9V 1A powerSupply.
Only my Movi circuit board gets hot but not my Arduino.
If i turn on my Movi + Arduino without anything connected it gets hot.
I am not using another shield in my setup.

I measured the voltage of the IOREF Pin: its 5V
I removed the bride of Jumper 1
I tried one of the basic example program with just MOVI + Arduino-> Movi hot…

Here you can see my circuit diagramm:
Arduino-Schaltplan

If somebody has an idea why my movi gets so hot i would be pleased to get an answer. :):grin:
I would like to add that the support is very nice because they answer very fast and give some good possibilities why my board gets so hot.

Thanks,

Yann

Can you measure the current between your battery holder and your Arduino/MOVI combination? The current should be roughly around 200mA, peaking at 500mA at boot time.